Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Roger68
Roger68
Just browsing
Member since Aug 8, 2019
Aug 12 2019
Community Record
4
Posts
0
Kudos
0
Solutions
Aug 9 2019
9:15 AM
Thanks a bunch for the additional information, you guys are the best!
... View more
Aug 8 2019
1:39 PM
Thank you very much to everyone who has replied to my thread with information, I am pleased the MX65 can accommodate the dual WAN failover setup rather than sending back this 4G LTE device. Thanks again for the super fast support!
... View more
Aug 8 2019
11:45 AM
So it will automatically use WAN1 by default and will switch over to WAN2 only if WAN1 fails? Then will switch back to WAN1 when connection is reestablished? No special configuration required to make that happen? Thanks a bunch for your input!
... View more
Aug 8 2019
9:32 AM
I have been having issues with my ISP dropping connection so I ordered their 4G LTE failover service, unfortunately it uses NAT and cannot pass through my static IP's to the MX65 and will not work with my configuration. I have been reading about a dual WAN setup on the MX65 which sounds like it might be a viable solution, I would setup the primary WAN for the static IP and let the secondary WAN use DHCP from the 4G LTE device. My question is, can I configure the MX65 to use the primary WAN unless it doesn't have connection at which point it would use the secondary WAN for internet traffic? Thanks for taking the time to read about my issue, and for any advice you may have to offer.
... View more
© 2024 Cisco Systems, Inc.
