Please, in the link below is mandatory a one-armed concentrator to establish a EBGP connection in the DC side? Is it not possible to establish a EBGP connection between the L3 switch and the MX? https://documentation.meraki.com/MX-Z/Networks_and_Routing/BGP
... View more
Actually depending on where these clients are located and if they are behind say an access point and you have any type of splash page configured your Meraki device advertises it's splash page as 1.1.1.1 Maybe this will help maybe it will not. You can tell if this is happening if you run a pcap you will see ARP from the Meraki device for 1.1.1.1
... View more
thank you for your response, now I know it is only possible at owner mode, and the test I´ve been doing was not really that mode, I´ll do more test when I jave the devices, and fi it not works, I´ll try the way you said.. thank you!
... View more
Thanks to all for replying, I didn't receive notification of thread replies hence the delay. It sounds like in my structure, I might be better off having each switch do its own thing (multiple VLANs), since I can't logically break out the areas to have one or two core switches.
... View more
@RH6379 wrote: We're installing 12 MS-120 switches in a remote office and the switches are showing a DNS misconfigured error when we use the IP of the mgmt vlan as the DNS Server. That is configured on an MX84. Is your MX84 not configured as a DNS proxy perhaps? If it's not relaying and returning DNS queries and responses for clients, then the switch isn't going to connect either.
... View more
