Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Ron-Sungard
Ron-Sungard
Conversationalist
Member since Jul 31, 2019
Oct 5 2021
Ronald Reid
London
Community Record
7
Posts
0
Kudos
0
Solutions
Badges
Apr 27 2021
11:21 PM
Follow up on my post. With the port disconnected, the alerts cleared on the switch after a few hours. As mentioned, the alerts would not clear while the port was active. Meraki needs to put out a notification for this.
... View more
Apr 27 2021
6:36 AM
I haven't raised a ticket on the issue. I was hoping it was just an alert history issue and the alerts would clear of their own accord but it looks like a bug. I've only just moved my trunk to a different port so I have to wait an see if the switch stops alerting tomorrow.
... View more
Apr 27 2021
5:54 AM
I have the same problem on a trunk. There was a genuine problem on the port that was cleared, but the alert would not clear even after 24 hours, so I moved the the connection to an adjacent port to test, and got no alerts on that port. The switch still reported alerts on the now vacant port. My switch version is 12.33
... View more
Aug 28 2020
1:19 AM
Apologies for the late reply. The configured antenna is a Dual-Band Omni (MA-ANT-20), not MA-ANT-3-A5 as stated (my mistake). The antenna however has not yet been installed because COVID19 has prevented technical staff from attending site. Is installation a requirement for the message to go away?
... View more
Aug 25 2020
7:14 AM
I have two MR74 AP's configured with MA-ANT-3-A5 antenna and I'm receiving the following warning: "We have noticed that one or more MR74 APs in your network do not have their antenna information configured. Antennas must be configured for both bands to ensure regulatory compliance..." As far as I can see the antenna are configured for both AP's so I haven't a clue what the message means. The links provided in the message have no useful information either. Does anyone know what this message means, or what I need to do to make it go away?
... View more
Feb 21 2020
3:48 AM
Yes thanks, I found this but there is an additional setting to be changed in the event of intermittent packet loss on a circuit, the active-active autovpn must be set to disabled or Meraki will still try to use the previously defined uplink and the vpn will be unstable.
... View more
Feb 20 2020
6:59 PM
Hi, I hope someone can help with this. I have an MX appliance with an active WAN1 connection to the internet that is showing packet loss (about 20% packet drop). The WAN2 connection is in a ready state and I need to manually fail over the connection to WAN2 because tme MX appliance isn't doing so because it still sees WAN1 as connected. How do I do this?
... View more
© 2025 Cisco Systems, Inc.
