Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About TFreer
TFreer
Comes here often
Member since Nov 9, 2017
May 20 2024
Community Record
13
Posts
0
Kudos
0
Solutions
Badges
May 18 2024
5:47 PM
Atlas by any chance? We had a bad batch of them a while ago warrantyed out a whole sites worth of them.
... View more
Dec 9 2022
8:56 PM
If you have a 10g switch to handle the ATT uplink then you could put one AP each with a different network/SSID in each apartment. Then each AP with its 1gb uplink would cover each apartment and no one can consume more them 1gb cause of the uplink limitation.
... View more
Jun 17 2022
1:39 PM
has anyone got the MT30 working with the webhooks into infromacast? if so is can you share a sample of the process you used to get it working. I have it working with the email alert but not the best idea for a lock down button when there is a 30-60 delay while the email gets sent to fusion.
... View more
Has anyone with 390's already upgraded to this yet and how stable is it? I got a maintenance window next week and want to see if it's worth upgrading yet. still on 14.33 now.
... View more
Feb 8 2022
8:34 AM
Does anyone with 390's and L3 on it install this yet? and is it an improvement from 14.32?
... View more
Dec 29 2018
8:47 PM
Has anyone else seen this, On firmware 10.40 and 43. When a L3 change is made within a OSPF area (ex add a new interface) my 425 in the area stops routing all OSPF and keeps flapping all neighbors between down and init. Even when the 425 is rebooted the issue comes back. The only way I have found to clear out the issue is to factory reset the switch, and even then when another change is made the issue comes back. I have replaced the 425 with a Cisco switch and I can not replicate the issue on that so it looks to be an issue with the 425.
... View more
Nov 9 2017
2:24 PM
the errors go away when changing to 12. it looks like its a bug in the meraki query interval on the MS 420. the RFC standard is 125 and it looks like some one forgot the 5 at the end of the number.
... View more
Nov 9 2017
6:01 AM
I am trying to set up PIM multicast routing between a cisco switch and a meraki MS420. on the cisco side I am getting the following error from the meraki switch. %IGMP-3-QUERY_INT_MISMATCH: Received a non-matching query interval 12, from querier address I have change the "ip igmp query interval" from the cisco standard "60" to the rfc standard "125" and still get the same error.
... View more
© 2024 Cisco Systems, Inc.
