Meraki

Kirillg88 · ‎Jul 20 2019

Thats ok, thanks a lot anyway 🙂

Kirillg88 · ‎Jul 19 2019

@kYutobi wrote: That way is correct for redundancy. I just wasn't sure if you wanted to change your current config. @AjitKumar thanks. @Kirillg88 wasn't sure if you were going to stack the switches together in 2nd room which I should've asked. Yes , i have mentioned that im going to stack them 😉

Kirillg88 · ‎Jul 19 2019

@AjitKumar wrote: Hi @Kirillg88 With my Limited Knowledge I can think of following Connectivity. May be @kYutobi can suggest mistakes in this diagram. Thats exactly how i thought to do it , but wasnt sure if it's the right way

Kirillg88 · ‎Jul 19 2019

Yes , im just adding another switch and i'll make a stack of 2 switches . How should i uplink the new switch from the MS225-48 port 51,52 aggregated if both of them connected to aggregated ports in 1st server room. Should i take 1 link to the new switch ? Then aggregate ports on the new switch and connect to 1st room ? For example : 2nd room MS225-48 port 51,52 aggregated port 51 to port 27 , port 52 to MS225-48 port 52 (1st room) MS225-24 port 27,28 aggregated port 28 to MS225-24 port 28 (1st room)

Kirillg88 · ‎Jul 19 2019

Hi guys. Need a little help with configuration. I'll describe my CURRENT config : 1st communication room Stack of MS225-48 port 49 uplink port from master MS225-24 port 25 uplink from slave PORT 52 and PORT 28 aggregated 2nd room MS225-48 port 51,52 aggregated 51 going to port 28 (1st communication room) 52 going to port 52 (1st communication room) I'm about to add another MS225-24 to 2nd room (Will be stack with MS225-48) Now the question is how im doing the aggregation correctly after i'll add another switch NOTE: I have only 2 optic cables coming from 1st communication room to 2nd Hope i was clear. Thanks !

Meraki

Community

About Kirillg88

Kirillg88

Community Record

Badges

Re: Port aggregation

Re: Port aggregation

Re: Port aggregation

Re: Port aggregation

Port aggregation

Re: Port aggregation