I followed the documentation setting up the connection but the MPLS connection on WAN 2 of the MX doesn't ever say connected. Configuring Site-to-site VPN over MPLS - Cisco Meraki Design Data Center at HQ has a core switch with a VLAN 700,701 each have an assigned IP address on those interfaces. Have one port on this switch configured as a TRUNK port that connects to our ISP for our MPLS. Both remote sites are using this one port with 2 different vlans. Remote Sites - First remote site has a MX and with an internet connection that is working over the Site to site VPN - WAN 1 connecting back to a VPN concentrator at HQ. On WAN2 I configured this port to have a static IP for VLAN 700. This connection never comes up. I previously had a L3 switch at the remote site that had a trunk port with a native vlan set to 700 and an IP address assigned to the vlan 700 interface. Default route back to the HQ vlan 700 interface IP. Am I required to still have a L3 switch on the remote side so the MX connects into a access port on the switch? Or can it connect into trunk port from the HQ going across the MPLS connection.
... View more
