In cases where we have loadbalancing enabled over a template that has sites that are using a wired primary connection and keeping an active sim chip for possible failover in the event that the primary connection goes down, will the firewall try to load balance over the cellular sim card connection?   I know if we connect a cradle point the device will try to loadbalance over the secondary connection but will that happen over an MX with a sim chip?   If anyone here knows for sure please let me know.   Thank you. ... View more

I have a design question.  We are deploying Cradlepoint cellular gateways to a number of our larger boutiques and we have been asked if this set up is possible?   Fast Circuit goes into line 1 of MX1 Slow circuit goes into line 2 of MX1 Fast circuit goes into Line 1 of MX2 Cradlepoint goes into Line 2 of MX2   I do not think this set up is feasible but I am not well versed in the firewall cluster architecture.  Can anyone here on the forum share their thoughts on this approach?   Thank you. ... View more

Hello all,   Does anyone here in the forum have experience with integrating their Ekahau surveys into the Meraki site dashboard?  We already own a number of Ekahau Side kick 2 devices and we perform the surveys.  What would be involved in pulling those surveys into Meraki and integrating the Ekahau tools?  Since we already own the side kicks and we have user licenses, would their be any additional costs?   Please let me know if you do.   Thank you. ... View more

Does anyone here in the forum know if a script I could run to retrieve the Meraki MX uptime from the sites in my portal that I can download to a csv spreadsheet?  I am currently updating this information manually each month from the summary page for each boutique and its KILLING ME!    Please let me know if you do.   Thank you. ... View more

We performed a switch upgrade last night and one of the switches came up with the wrong ip address but the equipment that is connected to it appears to still be reachable. The boutique is currently open and I would prefer not to disturb them during production hours. Will the devices connected operate normally today with this being the situation? Or should I reboot this switch now and interrupt production?   Please let me know if you do.    Thank you. ... View more

Does anyone here in the forum know if there is a way to add the cameras we have in several of our boutique locations to the event logging in the Meraki portal?  If so can you please share that with me?   Thank you.   Rgds, Vicky ... View more

I currently have a ticket where the user wants me to change the dynamically assigned equipment ips to specific and static ones. The management vlan is set with local dhcp.  I was thinking of just setting up reservations and then rebooting the devices one by one to accomplish this. Does this sound like a safe approach to this request?   Please let me know your thoughts.   Thank you.   Rgds, Vicky ... View more

Hello all,     Basically we have an offsite location where we need a wired connection and all we have are RJ11 jacks.  Is there any way we can use an adapter to change the connection to RJ45 for our switch that will work??   Any suggestions or input here would be much appreciated.   Thank you.   Rgds, Vicky ... View more

We have an office that wants to use two cisco small business switches with an MX64.  Can we add the meraki vlans to the cisco switch config and expect it to work properly?  Or do we need to keep all of the ports at native vlan 1?   Please let me know.   Thank you. ... View more