About EduardoML

EduardoML · ‎08-15-2019

Hey guys thanks to all for your answers. I reached out to Meraki support. First of all, they will enable FQDN to be configured on the Non-Meraki VPN peers, then The recommend custom profile is: Phase 1 Encryption AES 256 Auth SHA-1 DH group 5 Lifetime default 28800 Phase 2 Encryption AES 256 Auth SHA-1 PFS group Off Lifetime default 28800 After I had the parameters configured, they asked for my confirmation, and I guess then is when they enable the IKEv2 parameters for the specific VPN. Also, another recommendation is to create a test VLAN to be the one available for the VPN as the traffic from this subnet will be sent to the Umbrella CDFW

EduardoML · ‎08-14-2019

Hello, Anybody has succeeded with implementing a Site to site VPN to Umbrella cloud? I've seen on Umbrella documentation that it is supported but no guidance on either Umbrella or Meraki documentation sites. https://docs.umbrella.com/deployment-umbrella/v1.0.6/docs/supported-ipsec-parameters Regards, Eduardo

EduardoML · ‎10-23-2017

Hello Community! I was wondering if you could help me determine if it is possible to use the vMX 100 in multiple zones/subnets As far I've seen in the setup guide it only mentions when installing to select a VPC and then a subnet from that VPC. But is it possible to use it for more subnet or does it will only work within the subnet of the VPC where it was installed? Kind regards, EM.

EduardoML

Community Record

Badges

Re: S2S VPN to Umbrella

S2S VPN to Umbrella

vMX 100 multiple subnets