Meraki Community

JulioG · ‎Apr 1 2019

Believe it or not, but it works for me. .- Use new network cable .- Use a old router (4 port) to configure the merakis. I configured the router as a simple device of my network and then connect to it the the merakis, configure the merakis with the data of my branch office and wuaala the merakis work fine as gateway. I have no explanation for it Thanks for your replies.

JulioG · ‎Apr 1 2019

To discard the error of IP address, I wrote the same IP, Gw and DNS at one notebook, and it go to internet with no problem.

JulioG · ‎Apr 1 2019

At my main office the AP work as gateway or repeater. At the branch office the AP have to be gateway. No, I don´t move to other network at the dashboard. they are at same network.

JulioG · ‎Apr 1 2019

Hi, I have a merakis MR33 , I configured it at my Headquarter (IP, Gateway and DNS) and it work fine as Gateway or Repeater. Then a configured with the address for a branch office and move to that location, but the MR33 don´t work in that location. The merakis do not show any ssid they do not even show the ssid meraki-scan Here my tests I configured a Notebook with the data of 1 meraki, and the notebook go to internet, so I discard problem with the configuration of network I change network cable I change POE injector (meraki) and use a generic I try to connect with a network cable So, I returned to my headquarter and here the meraki works fine again , shows meraki-scanning and the other ssid Could be error of firmware or Electrical Power? Thank you for any help

Meraki Community

About JulioG

JulioG

Community Record

Re: MR33 no longer broadcast SSID

Re: MR33 no longer broadcast SSID

Re: MR33 no longer broadcast SSID

MR33 no longer broadcast SSID