Meraki

Simon_Laffoley · ‎Mar 14 2019

I agree handsets are best on an access port, but they can work in a trunk too. I was referring to the cisco router part of the phone server solution providing DHCP that was trunked. I don't know why it was setup as trunk as it only requires a single vlan, done before my time.

Simon_Laffoley · ‎Mar 13 2019

Yep my Bad The Cisco Phone system was connected to a trunk native VLAN13 but also allowed Vlan1. I've removed VLAN1 and we'll see how that goes. Thanks

Simon_Laffoley · ‎Mar 13 2019

Thats the weird thing. I have configured this many times using HP and Cisco and have never seen this before. There is not much to the configuration, access port , data vlan ID, voice vlan ID. trunk on the uplink with vlan 1 being native. I can trunk the port with vlan1 native and data/voice as allowed but then I can't use 802.1x in a future access policy.

Simon_Laffoley · ‎Mar 13 2019

Hi All I have a Meraki MS225 acting as an access switch having VLAN1 as Data and VLAN13 as Voice. I have separate DHCP Servers on each VLAN, VLAN1 as a windows DHCP Server. VLAN 13 as the phone system server. I have a PC Only plugged into this port. Sometimes I get DHCP assigned IP from the voice vlan on the PC on startup. If I release and renew after login i get a correct IP Address allocated. Why would this happen? would i need to remove and add the voice vlan after every telephone move? Any Ideas greatly received

Meraki

Community

About Simon_Laffoley

Simon_Laffoley

Community Record

Badges

Re: Access Port Voice Data VLANs and DHCP

Re: Access Port Voice Data VLANs and DHCP

Re: Access Port Voice Data VLANs and DHCP

Access Port Voice Data VLANs and DHCP

Re: Access Port Voice Data VLANs and DHCP

Re: Access Port Voice Data VLANs and DHCP