cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
  • About Jetpilot45

Re: Meraki VPN Client

by in Security / SD-WAN
‎11-23-2017 07:16 PM
‎11-23-2017 07:16 PM
@CarlosCoque  I am having the same frustrating issue. I've spent over 3 hours trying to fix this VPN issue on windows 10-1709. iPhone/ipad with ios11 connects to my MX64 L2TP VPN so easily. My windows computer is on the same network as the phone and returns error 809 all day long and will never connect. Following the setup instructions from Meraki will not work on Windows 10. My MX64 is not behind a NAT. It is connected to a modem in bridge mode so it pulls a public IP.  I also completed the registry edit microsoft recommends but it's not the problem. ... View more

Re: Verizon USB Modem support

by in Security / SD-WAN
‎11-02-2017 11:04 AM
‎11-02-2017 11:04 AM
Thank you Jeremy/ @InseegoSupport Because I need to get the timing correct regarding when to plug in the USB730L during MX bootup, I suspect a firmware issue. @smartin I also can't see any updates available beyond 13.25 and am asking the same questions regarding 14.17. ... View more

Re: Verizon USB Modem support

by in Security / SD-WAN
‎11-01-2017 07:18 AM
‎11-01-2017 07:18 AM
I found this thread informative. I had a related question regarding the USB730L. It's now officially supported by Meraki. Does anyone know the proper way to boot both devices to use the USB730L as a primary wan connection? I need to run an outbuilding for a few days without ethernet wan.    If I plug it into a unpowered MX64 and add power, the final result is the solid orange light on the MX while the Verizon is solid green and ready to go. Would it be better to boot the MX64 without the USB730L until orange light then plug it in?    Notes: MX 13.25 firmware USB730L works fine when plugged into a laptop ... View more

MX-64 Wired network user access

by in Security / SD-WAN
‎09-15-2017 05:41 PM
‎09-15-2017 05:41 PM
I'm very new to the Meraki ecosystem but I tried to search and cannot find an answer.    There's probably multiple ways, but how do I configure my MX-64 to use a MAC address table that I set to allow connectivity to clients under this firewall/router? I want an unknown device to be blocked from my meraki network unless I specified its MAC address in settings. So basically, block every client/device unless whitelisted. This question is in reference to a wired network. Firmware MX 13.23 Thanks! ... View more
© 2023 Meraki