Meraki

Heath_Rose

So when talking about the MX75 Hub, I have (2) network connections. Connection 1 is the public Internet connection that I have connected to WAN1 and Connection 2 is the Enterprise Network 10.0.0.0/8 I have connected to WAN2 Would this be the proper way to connect this?

Heath_Rose

I have a computer connected to the MX75 spoke and can connect to the internet over the tunnel, but I cannot connect to the internal 10.0.0.0/8 network. I cannot ping or connect to anything on the 10.0.0.0/8 network at all including DNS. I have a firewall rule on the Hub

Heath_Rose

I have (2) Meraki MX75’s and am trying to get them to work as a Hub and Spoke. I have one of the MX75’s in our data center and have the WAN1 port connected to an external public IP 168.166.x.x address. The 168.166.x.x address only has access to the internet and does not have access to our Internal Company Network. I have another port/IP address of 10.1.x.x and have it connected to the WAN2 port on the Meraki MX75. I have the Site-to-Site Auto VPN working between both the Hub and Spoke and have internet access on the poke but I can not figure out how to get the spoke access to our Internal 10.x.x.x network. Does anyone have experience with this or any ideas on how to accomplish this?

Meraki

Community

About Heath_Rose

Heath_Rose

Community Record

Badges

Re: Site-to-Site VPN Can't Access Internal Network

Re: Site-to-Site VPN Can't Access Internal Network

Site-to-Site VPN Can't Access Internal Network