Hey all, looking for some guidance on configuring our updated network setup. Here’s what we’re working with: Current Site Layout Site A - MX95 with 2 WAN connections, network 10.40.1.0/24 Site B (new site) - MX95 with 0 WAN connections, network 10.50.1.0/24 Site C - MX75 with 1 WAN connection, network 10.30.1.0/24 Site D - MX75 with 1 WAN connection, network 10.20.1.0/24 All sites have Meraki Layer 2 switches. Sites A, C, and D currently use AutoVPN to share resources hosted at Site A. Site A will be dropping one WAN connection in lieu of the Comcast EDI. Upcoming Changes Comcast EDI circuits are being installed at Site A and Site B. All sites will be connected via Comcast ENS circuits. WAN connections at Site C and D will be removed — ENS will be the only uplink. Goal is to configure Site A and Site B in a failover setup to provide internet to all sites in case of an outage at either location. Questions & Considerations I found Meraki’s doc on MPLS with AutoVPN as backup, but unsure if it applies since we’re not using MPLS. I’ve read that the easiest method is to remove the MX75s and plug ENS directly into the L2 switches to “extend” the network — but that’s not an option for us, as MGMT want to use the MX hardware they purchased for the branch offices... I’ve browsed Reddit, Spiceworks, and Meraki forums, but haven’t found a setup quite like ours. I did see a few threads that spoke of using Static Routes and such, but I'm just not sure. I'll admit, I am new to Meraki and Comcast ENS, as my team usually deploys Watchguards and standalone internet to each site. Any advice or configuration tips would be greatly appreciated. Thanks!
... View more