Meraki

Meerkat99

Hi, no they are routes from within the same organisation. Tks

Meerkat99

On further investigation, it seems like the hub with the large routing table is receiving the same route from the other hubs in the network (ie the same subnet appears 5 times, each from a different hub), whereas a hub with the ‘expected’ route table is only receiving the route from its spoke site. Can anyone please advise why this is?

Meerkat99

Tks will have a read

Meerkat99

Thank you, it was Meraki support that suggested a hard limit of 10k but I haven’t seen any documentation to confirm this.

Meerkat99

Hi folks, Can anyone please advise if there is a finite number for the amount of routes that can populate the MX-100 routing table before routes are no longer reachable? For example, in our hub and spoke configuration, we have run into instances where a client on a subnet advertised from a spoke (ie 172.25.80.0/27) is not reachable from the MX Hub who’s routes are in excess of 11500, however clients on the same subnet are reachable from a 2nd Hub who’s routing table has approx 3k routes. Hope that makes sense! Thanks..

Meraki

Community

About Meerkat99

Meerkat99

Community Record

Badges

Re: MX-100 Route Table

Re: MX-100 Route Table

Re: MX-100 Route Table

Re: MX-100 Route Table

MX-100 Route Table