Meraki

Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

About iPhilT

Re: MX Warm Spare Query

by in Security & SD-WAN
‎Mar 4 2019 2:51 AM
‎Mar 4 2019 2:51 AM
Thanks Phil.   ... View more

Re: MX Warm Spare Query

by in Security & SD-WAN
‎Mar 4 2019 12:15 AM
‎Mar 4 2019 12:15 AM
Dear Philip,   Thanks for your reply.   I can do what you suggested for WAN2 MPLS - which means i need to use Virtual IP correct? The LAN IP is routable to the internet. Will that help? if I use Virtual IP on the LAN IP as well?   Also what does "Use MX uplink IPs" mean? in what scenario do we use this?   Thanks. ... View more

MX Warm Spare Query

by in Security & SD-WAN
‎Mar 3 2019 11:37 PM
‎Mar 3 2019 11:37 PM
Dear All,   Im a newbie in the community & new to Meraki as well. 🙂   I had a question regarding MX Warmspare setup in Routed Mode.   My setup is as follows: WAN1 Connected to ISP on a /30 subnet for which i get IP from DHCP WAN2 is MPLS Link connected to a single router LAN Connected to MS Switches   Can i configure Warm-Spare in this setup using the "Use MX uplink IPs" So that the configured IPs on MX1 just fails over to the spare MX2. Note that WAN1 has only 1 IP available. ... View more
© 2024 Cisco Systems, Inc.