Meraki

iPhilT · ‎Mar 4 2019

Thanks Phil.

iPhilT · ‎Mar 4 2019

Dear Philip, Thanks for your reply. I can do what you suggested for WAN2 MPLS - which means i need to use Virtual IP correct? The LAN IP is routable to the internet. Will that help? if I use Virtual IP on the LAN IP as well? Also what does "Use MX uplink IPs" mean? in what scenario do we use this? Thanks.

iPhilT · ‎Mar 3 2019

Dear All, Im a newbie in the community & new to Meraki as well. 🙂 I had a question regarding MX Warmspare setup in Routed Mode. My setup is as follows: WAN1 Connected to ISP on a /30 subnet for which i get IP from DHCP WAN2 is MPLS Link connected to a single router LAN Connected to MS Switches Can i configure Warm-Spare in this setup using the "Use MX uplink IPs" So that the configured IPs on MX1 just fails over to the spare MX2. Note that WAN1 has only 1 IP available.

Meraki

Community

About iPhilT

iPhilT

Community Record

Badges

Re: MX Warm Spare Query

Re: MX Warm Spare Query

MX Warm Spare Query