Meraki

Kau1 · ‎Jun 11 2025

Thanks DarrenOC.. yes SW01 is the main switch but only a L2 device. OK thanks, will try the loopguard setting.

Kau1 · ‎Jun 11 2025

Thanks for the response RaphaeIL.. should I need to make any changes on the Peplink then as it should be acting as a Router essentially?

Kau1 · ‎Jun 11 2025

I have a couple of Meraki Switches in my topology (MS-130s) both of them. Current version: MS 17.2.1 The SW1 connect to SW2 via port 1. I have configured SW01 to be priority 4096. SW01 (priority 4096) via port 1. However, when we are trying to use a Peplink SD_WAN device to connect to port 17 on SW01, keep getting and the below comes up on the event logs And the port 17 goes orange Can you please advise if there is anything that could be causing this?

Meraki

Community

About Kau1

Kau1

Community Record

Re: STP BPDU sender conflict

Re: STP BPDU sender conflict

STP BPDU sender conflict