Meraki

Community
  • About Chapelhill_IT

About Chapelhill_IT

Re: Moving DHCP to L3 MS-425

by in Full-Stack & Network-Wide
‎May 30 2025 7:03 PM
‎May 30 2025 7:03 PM
Just went thru the Layer 3 routing course and it def helped clarify a few things.  I did come up with a few questions regarding affect on site to site VPN.  Responded to your direct message with that concern. ... View more

Re: Moving DHCP to L3 MS-425

by in Full-Stack & Network-Wide
‎May 30 2025 4:50 PM
‎May 30 2025 4:50 PM
Do i only keep the Management VLAN in the MX but move all VLAN / DHCP (including DHCP for management VLAN) over to the MS?  Referring to this article: https://documentation.meraki.com/Architectures_and_Best_Practices/Recommended_Topologies/MX_and_MS_Basic_Recommended_Layer_3_Topology   Trying to make sure in the move i don't suddenly break access to switches if that makes sense. ... View more

Moving DHCP to L3 MS-425

by in Full-Stack & Network-Wide
‎May 30 2025 4:40 PM
‎May 30 2025 4:40 PM
We currently have an older MX-100 that is running VLANs / DHCP for the entire site.  We run about a dozen VLANs.  Currently the MS-425 is a L2 switch.  We have a pretty substantial inter-VLAN traffic flow and I'd like to move the DHCP / VLAN configuration from the MX to the MS.  What is the best process to make this change and minimize downtime?   Can i setup everything in the MS-425 first and let the MX keep handling the traffic and then make a hard change to the MS device?  From what i've read i only need to configure one access VLAN on the MX when all is said and done?   Thanks for the advice here. ... View more
© 2025 Cisco Systems, Inc.