No There is no any separate rules added. There are 17 APs in the network but this issue is only for few APs ... View more

Yes — you can change/upgrade the antennas on the Meraki MR76.   The Cisco Meraki MR76 is designed for external antennas and supports 4 × N-type antenna connectors. Antennas are not included by default, and you must connect all four ports to maintain proper MIMO operation. Key points   • You can use Cisco Meraki–approved antennas or third-party antennas that match the required specifications   • Supported antenna types include omnidirectional, sector, and patch antennas   • Antennas must be dual-band (2.4 GHz & 5 GHz) and use N-type connectors   • Antenna choice impacts coverage pattern, gain, and regulatory compliance Recommended (official) Meraki antennas   Common compatible models include:   • MA-ANT-20 – Dual-band omni antennas   • MA-ANT-21 / MA-ANT-23 – Sector antennas   • MA-ANT-25 / MA-ANT-27 – Higher-gain directional options   (Refer to the MR76 datasheet for the full supported list.) Where to buy   • Cisco partners / resellers   • Online retailers such as Amazon, NetworkTigers, CDW, Comms-Express, etc. As long as the antenna meets the MR76 specifications (N-type, dual-band, correct impedance and gain), it can be used. However, Meraki recommends using their approved antennas for guaranteed performance and compliance.   ... View more

No, Meraki Sponsored Guest Wi-Fi does not support restricting or predefining the sponsor email address in the Dashboard. The sponsor email is entered by the guest and cannot be locked to a specific user (e.g., reception). To achieve this, you must use a custom splash page and hard-code the sponsor email in the backend. Alternatively, use a shared reception inbox as a manual workaround. ... View more

No the beacon interval cannot be changed from the meraki dashboard. They fixed it at 100ms and is not configurable by administrators.   But you can do few things to reduce air time, Disable low data rates Prefer 5Ghz/6Ghz Adjust Minimum Bitrate per SSID Tune TX Power and channel width   And keep this in mind, Changing beacon intervals can; Break roaming behaviour Cause battery drain on mobile clients Create inconsistent RF behaviour across APs   Let me know the use case for more relevant answer ... View more