Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Register or Sign in
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About rafi
rafi
Comes here often
Member since Oct 5, 2018
Jun 23 2022
Community Record
9
Posts
0
Kudos
0
Solutions
Badges
Jun 21 2022
11:03 AM
Thanks so much for the detail on your response. I will be looking into other restrictions as recommended. Much appreciated.
... View more
Jun 17 2022
4:57 PM
Thanks for responding. I was not aware they would be dynamic... I have my own hot spot from work but not everyone was given one. So, there would be no way to set that up since the IP changes on the users end? AnyConnect I just noticed on our MX is this a new offering by Meraki? I have it disabled and using the IPSec.
... View more
Jun 17 2022
1:34 PM
Hello there~ I am looking for some help on a couple of things that our auditors recommended we do with our client VPN connections. One of them is attempting to filter each client by their IP address. Is this possible on a MX100? how can I further protect the client VPN connections from the attack surface standpoint? Much appreciated. Rafael~
... View more
Mar 23 2021
2:00 PM
Thanks for the help. Requirements for this project have changed and I have no need to extend the network there anymore. (: -- I do appreciate the responses.
... View more
Mar 20 2021
12:37 PM
Actually when I was testing the trunk port on both switches is admin all. I will test again.
... View more
Mar 20 2021
12:36 PM
I am using a MS250-24P. I will test tomorrow and see how it goes. Thank you.
... View more
Mar 20 2021
9:08 AM
Hi there, I added a cisco sg200-8 to an area where I need to add more than one device. I set the port as trunk and connected to the drop. On the meraki switch I see the switch on the port and made the port on the switch as trunk as well. However, the native vlan is 100 but if I change it on the cisco sg switch it looses connectivity (native vlan on all the switches is 100). Is this switch too old to work with the Meraki switches? what switch would be recommended to place here to extend the connectivity to other devices. Also, since the switch looses connectivity the device I plug in do not get connected. Any ideas or suggestions on what I can add on this area to extend the network? Much appreciated.
... View more
Oct 24 2018
12:55 PM
Thank you. I did come up with a list from Microsoft here. In case you are curious. https://support.microsoft.com/en-us/help/832017/service-overview-and-network-port-requirements-for-windows Rafael.
... View more
Oct 5 2018
4:14 PM
Hello~ I have a RODC in a location and users authenticate to it at that location. I want to make sure traffic is not blocked when RODC needs to communicate to DC at HQs. Firewall is not blocking outbound traffic but I am getting started in making sure that is filter. Does anyone know what tcp/udp ports I need to have in the firewall rule to allow this traffic? Thanks.
... View more
© 2024 Cisco Systems, Inc.
