Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Become a member of the Cisco Meraki Community today
Get answers from our community of experts in record time.
Join now- About Yahia
About Yahia
Yahia
Comes here often
Member since Feb 13, 2025
May 28 2025
Community Record
4
Posts
0
Kudos
0
Solutions
Apr 9 2025
1:44 AM
*"Network 1 has an MX security appliance with an established VPN tunnel to another site. Now, I want to create a new VPN tunnel from Network 2 (which also has its own MX appliance) to a different site — without any connection or dependency on Network 1's MX or its tunnels. However, when I try to save the new tunnel configuration in Network 2, a warning message appears. This message is only a warning and does not prevent saving the configuration.
... View more
Apr 8 2025
6:49 AM
Please note the a new tunnel on the different MX and network
... View more
Apr 8 2025
6:45 AM
I have two MX each MX in the sperate network MX-1 have Tunnel-1 remote site IP 10.0.0.0\8 MX-2 I want to create new tunnel to non-meraki device remote site IP 192.168.150.0\24
... View more
Apr 8 2025
6:06 AM
Hello I am encountering an issue when attempting to create an IPsec tunnel with a Non-Meraki peer. I received the following notification: The settings you requested require confirmation. Please review the following list: - The VLAN subnets 10.2.2.0/24, 10.40.40.0/24, 10.50.50.0/28, 10.33.33.0/24, and 10.44.44.0/24 overlap with a remote VPN subnet on the Non-Meraki peer Tunnel-1 (10.0.0.0/8). IP traffic will be routed to the smallest subnet that contains the IP address. - A subnet on the Non-Meraki peer Tunnel-1 (10.0.0.0/8) overlaps with subnets on the network Estarta TAC - appliance (10.238.70.0/24, 10.238.71.0/24, 10.238.76.0/23, and 10.238.78.0/24). IP traffic will be routed to the smallest subnet that contains the IP address. Could you please clarify why this notification appears and whether creating the tunnel will have any impact on the network or routing due to this overlap? Please note that Tunnel-1 is configured on the "X" network, while I am planning to create a new tunnel on the "Y" network. It's important to mention that the two networks are completely separate and have no direct connection with each other
... View more
© 2025 Cisco Systems, Inc.
