Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About lmt737
lmt737
Conversationalist
Member since Jan 29, 2025
Thursday
Community Record
6
Posts
0
Kudos
1
Solution
Badges
Thursday
the issue was not multicast at all. the page system had to have a settings change.
... View more
a week ago
Well, when the MS250 has a DHCP scope configured, you also have to configure an interface and static route. The interface is what the dhcp clients get and the static route is the route out to next hop. So dhcp clients get 10.10.10.2 as the gateway with a hop of 10.10.10.1. All static devices have a 10.10.10.1 gateway.
... View more
a week ago
@Mloraditch has posted a good guide about multicast. >Now I am getting reports that our paging system is ringing when an employee tries to page. No, when paging you want to page not ring.
... View more
a week ago
We have a 10.10.10.1 for static and gateway out to internet. The DHCP scope uses 10.10.10.2.
... View more
a week ago
I recently replaced a Cisco 2960x that ran a DHCP scope on vlan 1 (flat network) and replaced with an MS250. I configured a DHCP scope on the MS250. Now I am getting reports that our paging system is ringing when an employee tries to page. My understanding is that when you create a DHCP scope on an MS250, the device does layer 3 routing. Is this correct and will I need to enable layer 3 multicast on this device ?
... View more
Labels:
- Labels:
-
Other
My Accepted Solutions
| Subject | Views | Posted |
|---|---|---|
| 302 | Thursday |
© 2025 Cisco Systems, Inc.
