Meraki Community

Heino1

The interference was coming from the PIR. As a test, I wrapped aluminum foil around the PIR and the interference went down. Thanks for the PIR suggestion.

Heino1

There is a PIR-Sensor in this area. I will check how I can turn is off.

Heino1

Hi @thomasthomsen, thanks for your response. The building has several floors. The interference is very low above and below the floor with the interference. So I assume that the interference is on the floor of the AP. I will try turning off all power to the floor via the fuses and hopefully the signal will disappear. There is no other AP right next to this AP 😉 As a workaround, we already switched the clients to 5Ghz. Here are the RF-Spectrum from the floors 13-S (above) und 11-S (below).

Heino1

Hi there, we are seeing huge interference on channels 1-3 on the RF Spectrum page from two APs in the same area. We have no equipment running on these channels and the floors below and above us are also controlled by us and do not use channels 1-3. Have you seen this before? Do you have any idea how we can find the source of this interference? Kind regards, Heino

Meraki Community

About Heino1

Heino1

Community Record

Re: Huge interferences on channel 1-3 2.4 GHz

Re: Huge interferences on channel 1-3 2.4 GHz

Re: Huge interferences on channel 1-3 2.4 GHz

Huge interferences on channel 1-3 2.4 GHz