Meraki

Zer0kbps

I'll have to purchase some more stack-wise cables, I can't configure any speed or duplex settings on these ports as far as know. config is stack port 1 to port 2 on the next member and loops around from the bottom stack member to the top switch. Firmware wise they're on 16.9 I'll see if I can upgrade them late tonight to 17 build. maybe it's a resolved problem in that.

Zer0kbps

Hi folks, I have a never ending stream of the below messages, the switches in question are stacked using the stack wise cables and connected in the way described in Cisco's documentation, the switch in question the MS225-48FP and is the middle switch in a stack of 3, its port 53 is up and happy and beyond flooding logs, it's a happy performant switch. My question is, is this normal operation on a switch stack or should I be concerned. Nov 6 12:07:15 Port status change port: 54, old: 20Gfdx, new: down Nov 6 12:07:14 Port status change port: 54, old: down, new: 20Gfdx Nov 6 12:06:48 Port status change port: 54, old: 20Gfdx, new: down

Meraki

Community

About Zer0kbps

Zer0kbps

Community Record

Badges

Re: Stack Port - 54 up and like a yoyo

Stack Port - 54 up and like a yoyo