Meraki

Community

About Vlad_Ghimboasa

Re: MX-75 port Internet3, WAN2 physically not functioning

by in Security & SD-WAN
‎Aug 23 2024 8:02 AM
4 Kudos
‎Aug 23 2024 8:02 AM
4 Kudos
Hello everyone, we did a factory reset on the MX75 and the port internet3, WAN2 is now active. Thank you all for your time. ... View more

Re: MX-75 port Internet3, WAN2 physically not functioning

by in Security & SD-WAN
‎Aug 21 2024 7:47 AM
‎Aug 21 2024 7:47 AM
@PhilipDAth @Jinbe    Thank you for your answers, if I understand correctly, we can only "Enable Backup WAN on port 3" if we have three internet circuits? In our case, we have two internet circuits from different internet providers. how can we configure it? Thank you for your time ... View more

Re: MX-75 port Internet3, WAN2 physically not functioning

by in Security & SD-WAN
‎Aug 20 2024 1:24 PM
‎Aug 20 2024 1:24 PM
Our intention is to try again to enable the backup WAN, thanks for your answers. ... View more

Re: MX-75 port Internet3, WAN2 physically not functioning

by in Security & SD-WAN
‎Aug 20 2024 1:24 PM
‎Aug 20 2024 1:24 PM
Yes, there is no light whatsoever, we did not try the loopback, but the local status page indicates it is enabled. ... View more

Re: MX-75 port Internet3, WAN2 physically not functioning

by in Security & SD-WAN
‎Aug 20 2024 1:23 PM
‎Aug 20 2024 1:23 PM
Are you referring to this button?   We tried that, but it seems to switch all the configurations ... View more

Re: MX-75 port Internet3, WAN2 physically not functioning

by in Security & SD-WAN
‎Aug 20 2024 1:23 PM
‎Aug 20 2024 1:23 PM
Hi @Jinbe    Our firmware is MX-18.211.2. In our case, we use Internet2 as WAN1 and Internet3 as WAN2   The doc of the Multiwan backup Link is confusing us as it seems to contradict the following documentation:     https://documentation.meraki.com/MX/MX_Overviews_and_Specifications/WAN_Behavior_on_MX75%2F%2F85%2F%2F95%2F%2F105 ... View more

MX-75 port Internet3, WAN2 physically not functioning

by in Security & SD-WAN
‎Aug 16 2024 8:59 AM
‎Aug 16 2024 8:59 AM
Hi everyone,    We have 2 Internet connection from different providers. Both are perfectly functional when connected to port internet2, WAN1. It is our understanding that port internet3, WAN2 should automatically be available when a cable is connected to it. WAN1 and WAN2 are correctly configured. Even with our best efforts, WAN2 port internet3 is physically dead. Are we missing something?   Thank you   ... View more
© 2024 Cisco Systems, Inc.