Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About satokaz
satokaz
Comes here often
Member since Jul 27, 2024
Oct 15 2024
Community Record
4
Posts
0
Kudos
0
Solutions
All, Thank you for all the advice and comments. Also, thank you for the communication with support. I just checked the GUI and saw that it is now possible to select unlimited using the slider.
... View more
@Alexander3 Thank you for one solution. By setting all to 0 and saving, unlimited was set. Using iperf3, I was able to confirm that the speed exceeded 100Mbps. Save the above settings and check under Wireless -> Configure -> SSIDs:
... View more
@Brash Thanks for the reply. The MR46 is connected to a 2.5GbE unmanaged switch with a link up of 2500Mbit. When creating a new SSID, the "Bandwidth limit" is created with unlimited and exceeds 100M bps, so it is unlikely to be related to uplink negotiation. Even with the new SSID, the slider is set to a maximum of 100 Mbps, so if you change any settings in "Firewall and traffic shaping" and save them, 100M bps will be applied.
... View more
Hello, I am interested in Meraki and have just purchased the MR46 and MR Enterprise License.to begin with and am testing it. I did not purchase the Meraki MS or MX. Are there any limitations on network bandwidth when using MR alone? I can't select Unlimited on the Traffic shaping slider. The Traffic shaping slider allows a maximum selection of "100.0 Mbps" and I cannot select "Unlimited". Setting the "shape traffic" setting to "Don't shape traffic on this SSID" has no effect. In either case, When I look at Wireless -> SSID, it looks like the "Bandwidth limit" is limited to 100.0 Mbps. Any advice would be much appreciated.
... View more
© 2025 Cisco Systems, Inc.
