Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Wendy2
Wendy2
Here to help
Member since May 31, 2024
Jun 26 2024
Community Record
11
Posts
8
Kudos
0
Solutions
Badges
Jun 11 2024
6:49 AM
Yes, the core stack is the root bridge for all VLANS in the trunk. We have two other access switches in the topology. There is no impact to production as a result of this mac_flap so far.
... View more
Jun 11 2024
1:18 AM
2 Kudos
Site is fully up and functioning. No issue reported about from the MAC_flaps I have noticed. WAN is a separate thing, I agree
... View more
Jun 11 2024
1:10 AM
2 Kudos
Dashboard says 1Gbps full duplex Wondering if this issue is due to faulty physical cabling?
... View more
Jun 11 2024
12:32 AM
2 Kudos
Thanks for the reply. MX_105 running the same versions 18.107.2. We're using ethernet ports
... View more
Jun 11 2024
12:31 AM
Yes, it's identical to another site with the same topology. MX_105 running the same versions 18.107.2
... View more
Jun 11 2024
12:30 AM
Thank you for your response. MX_01 : Lan port into Cisco switch 1 trunk port. WAN into internet router. MX_02 : Lan port into Cisco switch 2 trunk port. This is a switch stack. Packet capture is showing a loop between the VLAN Interface IP's Checked spanning tree, and no errors. This site is setup identically to another site with no MAC_flaps
... View more
Jun 10 2024
6:48 AM
We have a site with 2 x MX in HA. We are seeing VRRP transition logs. The MX security appliances are frequently swapping between Master and Passive. VRRP transition old_mode detect prio 235 old_prio 235 elector_state master last_state_change_reason master_down_timer We are seeing MAC_flap logs on our Cisco switch. No impact has been reported, but this is the only site we're seeing these errors on. MX each have a lan port and wan port connected into separate switches in a stack. Haven't been able to figure this out yet.
... View more
Logs from the NIC on the laptop are showing frequent changes between wifi_802_11ac and wifi_802_11ax We have 2.4Ghz, 5GHz and 6GHZ enabled on the RF Profile. 802.11ax is enabled under 5GHZ. Could this be causing an issue? Could this be an issue?
... View more
We are having reports of users losing connectivity to wireless in our head office for about 20 seconds, whilst stationary at their desk. WLAN report Wireless security failed: Network Adapter: Intel(R) Wi-Fi 6E AX211 160MHz Dynamic key exchange did not succeed within configured time Error: 0x0 This is intermittent and not experienced by all users. Has anyone seen this and managed to resolve it?
... View more
Labels:
- Labels:
-
Other
My Top Kudoed Posts
| Subject | Kudos | Views |
|---|---|---|
| 2 | 2065 | |
| 2 | 2067 | |
| 2 | 2127 | |
| 2 | 2131 |
© 2024 Cisco Systems, Inc.
