Meraki

Alcon-Greg · ‎Dec 4 2018

SD-WAN is a way to make sure you internet traffic gets where it needs to go the most reliable way possible.

Alcon-Greg · ‎Jul 25 2018

I may have figured it out. The answer seems to be yes!! And set up a performance class of 100ms max latency, 100ms max jitter, 10% max loss. After setting up the AutoVPN, I went to Traffic Shaping and set up a VPN preference of load balance referencing the above performance class. Traffic is now going site-to-site over both WAN1 and WAN2 per packet sniffing. This is great!!

Alcon-Greg · ‎Jul 25 2018

We have 2 sites. Site 1 has 2 WAN circuits, MX80 Site 2 has 2 WAN circuits, MX64 we have a site-to-site VPN but it only utilizes 1 of the WAN circuits. Is there a way in Meraki to establish a site-to-site VPN on both WANs and load balance between the two for site to site traffic? Trying to get more site-to-site bandwidth without increasing circuit cost.

Meraki

Community

About Alcon-Greg

Alcon-Greg

Community Record

Badges

Re: Community Challenge: SD-WAN, Explained

Re: parallel site-to-site vpn

parallel site-to-site vpn

Re: Community Challenge: SD-WAN, Explained