Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About j_e_m_67
Community Record
8
Posts
0
Kudos
0
Solutions
Badges
Mar 7 2024
12:25 PM
I tried using the Firewall but doesn't match any SD WAN traffic, not seeing any hits. I could do this on Velocloud so not sure how this works on Meraki. I couldn't find documentation on anything related to firewalling SD WAN traffic. Thanks for any help! I will elaborate, I have SD WAN configured and is working fine. I would like to block certain traffic from being allowed over SD WAN from one of the spoke sites to the Hub.
... View more
Dec 12 2023
9:45 AM
Okay, got it thanks!
... View more
Dec 12 2023
9:41 AM
Thank you I am still confused about where to set the interface address for the intermediate network for connecting to the new layer 3 device.
... View more
Dec 12 2023
9:34 AM
Thanks for this documentation that is very helpful!
... View more
Dec 12 2023
9:33 AM
cmr, I don't see where to change a LAN port to a routed port where I can set an IP address on it.
... View more
Dec 12 2023
9:09 AM
Sorry, I should have mentioned it does already have an Internet connection on Uplink port 1. I am needing to add connection at the local site.
... View more
Dec 12 2023
9:02 AM
Hi, new to Meraki here. I am needing to connect an MX65 to another network device at the site. It is a layer 3 device which I will need to route some networks over, not technically a WAN and not an Internet connection. Would I still use an uplink port for this? Thanks! jem
... View more
Labels:
- Labels:
-
Other
© 2024 Cisco Systems, Inc.
