Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About emmaozoms
Community Record
57
Posts
9
Kudos
3
Solutions
Badges
Apr 19 2024
9:10 AM
Hello Guys, I noticed that setting the Meraki Cloud Authentication I cannot ping my LAN IP. Please how can I resolve this issue?
... View more
Apr 17 2024
12:29 PM
Is not Active Directly or EntraID. Looking for a way to just make staffs to enter their credentials whenever they want t access the wifi network so as to give me clear view of controlling and to secure the network from non staffs
... View more
Apr 17 2024
12:18 PM
I want staffs to use their username and password to authenticate the Network via the SSID Created on the network.
... View more
Apr 17 2024
11:54 AM
Thank you for the shared document. There is no radius server. Is there alternate way to still achieve this setup on the network?
... View more
Apr 17 2024
11:45 AM
Hello Guys, I need a way out to set my SSID for staff to authenticate with their username and password before accessing the network. All that is clear to me is using a preshared key. Please help.
... View more
Apr 17 2024
11:36 AM
This is the same I observed in the MT15 I installed. Is this normal?
... View more
Apr 16 2024
9:32 PM
Hello Guys, I installed MT15 between 6ft to 8ft from the ground based on the installation guide in the datasheet. The MT15 is connected to MS120. I observed the port the MT15 is connected to the MS120 is showing (Port disconnected), I tested the ethernet cable and it's all in good condition and also tried to connect MR36 to it and the device came online and shows the cable is ok. Please what likely can be the issue? Thanks
... View more
Apr 16 2024
5:25 AM
2 Kudos
I think that is the issue. So what I have decided to do now is to connect the MX68 with a static IP on the Vlan20 to connect on a truck port to the cisco 2960 switch and test if it will connect to the cloud. It was successful. Now I need to connect the MX to the Sophos LAN4 Port that has the VLAN20 Configured. I hope this will allow the MX come online. If it work is means the Sophos will be the upstream to the MX.
... View more
Apr 16 2024
1:22 AM
I allowed the MX to boot for long and it stopped at the orange LED. its a New MX. I have also don a fctory reset but same
... View more
Apr 15 2024
11:42 PM
ok noted. in addition, I observed that when I unplugged the cable from the WAN port of the Sophos and connect it to the Internet port of the Mx68, the there is still no reachability to the cloud for the MX. I assigned same IP that the sophos is connected to the MX. Is there something I need to do before the MX can connect to the cloud using this scenario ?
... View more
Apr 15 2024
11:24 PM
@DarrenOC Thank you so much for your response. I don't have a spare IP from the WAN Provider. There is a spare ethernet port on the NTE. Will the Spare port on the WAN Provider NTE assign DHCP to the MX if I connect it to it? Yes, the intention is to run both firewalls in parallel for now.
... View more
Apr 15 2024
7:37 PM
2 Kudos
From the sophos 1/Lan port is connected to a Cisco switch on port 2, Then Lan 4 on sophos is connected to port 3 on the Cisco switch(2960) while the port 48 on the cisco switch(2960) is connected to a router F0/0 Port. So what I have done presently is to connect the Meraki MS120 to port 5 on the 2960 switch as a trunk port. So I want to setup the MX68 to this existing network. The below is a rough sketch.
... View more
Apr 15 2024
7:06 PM
Noted. Do I need to click on the Layer 3 roaming? When I get to the office today I will test both the trunk and access as recommended.
... View more
Apr 15 2024
1:46 PM
Thank you for the shared document. Please do I need to statically assign IP ON THE mx68? I tried to use the ISP IP in the Sophos firewall to test if I can connect the MX68 to the cloud but the LED blinks different colors and stabled at Orange which means the device is not connecting to the Cloud. I also tried to use DHCP but same result. Can you advise on this Please.
... View more
Apr 15 2024
1:39 PM
So when I apply this as you advised means the OfficeWifi SSID will issue IP on the Local Lan?
... View more
Apr 15 2024
1:11 PM
I will do as you said and will update you if it resolves it. is there other things I need to check apart from the trucking the Port?
... View more
Apr 15 2024
1:05 PM
@alemabrahao Thanks for the response. this is the setting I configured on the port the AP
... View more
Apr 15 2024
12:59 PM
Hello Guys, I have a Sophos firewall and I want to integrate a new MX68 to work side by side with the Sophos firewall. Please how can I go about this?. Thanks guys
... View more
- « Previous
-
- 1
- 2
- Next »
My Accepted Solutions
| Subject | Views | Posted |
|---|---|---|
| 764 | Sep 6 2024 2:11 AM | |
| 1030 | Jul 30 2024 2:23 AM | |
| 3142 | Apr 16 2024 5:25 AM |
My Top Kudoed Posts
| Subject | Kudos | Views |
|---|---|---|
| 2 | 3142 | |
| 2 | 3196 | |
| 2 | 3321 | |
| 2 | 2416 | |
| 1 | 4388 |
© 2025 Cisco Systems, Inc.
