Hello All,
Not a wireless expert by any means.
I have an ethernet to wireless device (anybus bolt) that I have connected to an SSID. feeding off of that is an IoT device (PLC).
I can see the PLC connected, its IP, its MAC, able to ping the device through the meraki dashboard...it's connected.
However, I can't access this PLC over the network in any way...no ping, no trace route, can't see it as active in my management software.
I can connect a laptop to the SSID and have full network access.
I'm lost here and could really use some advice.
Re-set up an old cisco AP running off my cisco controllers and the PLC works as it should.
This must be something with meraki.
The bolt is not wifi6 capable so I did turn off 802.11x for both 2.4 & 5 Ghz.
Have a radio profile set to only use 2.4 Ghz.
Both devices are using static IP, but I did try with DHCP and both did pull an address.
any help is appreciated.