RF Spectrum data does not show the channels that are being used by AP's

[mike425]

Hi, has anyone seen this behaviour before?

If I look in the RF Spectrum page, it lists only channels 36-64 with any data. 

However, if I go to the RF-profile I can see the access points are using a larger spread?

 Any ideas?

[alemabrahao]

Have you confirmed if the channels are not setting manually?

[mike425]

Yes, the channels are set by an RF-profile, no manual allocation.

[cmr]

I see up to 140 on the RF spectrum page, but have many APs using higher channels than are reported there.  However the unreported channels are with HD APs like the CW9166 where the flex radio is often using 104-144 but it is not reported on the RF spectrum page, only the fixed radios are.