Please helpme i don get to come up an acces point

Solved
athan1234
A model citizen

Please helpme i don get to come up an acces point

With my fortigate, I wish to access the Meraki AP.

The issue is that the AP is not coming up even if the SW is coming up after I inserted a static IP address inside the range.

Any thoughts?

 

SW

athan1234_0-1715258870379.png

AP 

 

 

athan1234_1-1715258926171.png

 

 

port AP

 

athan1234_2-1715258964615.png

 

 

athan1234_3-1715258979343.png

 

FORTIGATE SIDE

 

athan1234_0-1715259160624.png

 

 

1 Accepted Solution
Purroy
Meraki Employee
Meraki Employee

As per your pictures... You need to set the native VLAN on the port that connects to your AP (port 11) to VLAN 40.  


Keep it as trunk and put the native VLAN on that port to VLAN40

View solution in original post

5 Replies 5
alemabrahao
Kind of a big deal
Kind of a big deal

Check if the AP is receiving IP and review your firewall policies.

 

https://documentation.meraki.com/General_Administration/Other_Topics/Upstream_Firewall_Rules_for_Clo...

 

I also suggest opening a support case.

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.
Purroy
Meraki Employee
Meraki Employee

As per your pictures... You need to set the native VLAN on the port that connects to your AP (port 11) to VLAN 40.  


Keep it as trunk and put the native VLAN on that port to VLAN40

ww
Kind of a big deal
Kind of a big deal

In that case, also remove the 40 from the vlan field of the ap management address

PhilipDAth
Kind of a big deal
Kind of a big deal

You need to get it to the point that if you plug a notebook into that switch port it can get Internet access.  Perhaps start at that point, and once that works plug the AP back in.

athan1234
A model citizen

thanks for your reply @alemabrahao @PhilipDAth @Purroy @ww 

 

@Purroy i putet the native vlan  like 40 and @ww  cjhange the mgmnt   the AP comes up without tag  thanks guys 

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels