Meraki Community

Keith_Li

Dear All,

I got a question would like to ask as i'm currently using MS-240-12P with AP MR44 & 76 in bridge mode, endpoint to endpoint could ping and reach each other, and just wonder there will be no port blocking in bridge mode right as i checked in Firewall & traffic shaping with specific ssid, its set to all allowed in local lan in wireless client accessing to lan, as customer reported the endpoint which connect to ssid could not print with airprint, as far as i know there is no port block at all within the bridge mode, please correct me if i'm wrong

Keith

rhbirkelund

If the SSIDs are set to Allow Local LAN, then there is nothing blocking clients to talk to eachother.

If you need to use Airprint, you might need to enable Bonjour forwarding on the SSID.

LinkedIn ::: https://blog.rhbirkelund.dk/

Like what you see? - Give a Kudo ## Did it answer your question? - Mark it as a Solution 🙂

All code examples are provided as is. Responsibility for Code execution lies solely your own.

Keith_Li

so i add a rule under Bonjour forwarding with specific vlan and all service ?

alemabrahao

There is the documentation.

https://documentation.meraki.com/MR/Client_Addressing_and_Bridging/Bonjour_Forwarding

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

Meraki Community

Meraki switch bridge mode question

Meraki switch bridge mode question