How to assign manual IP address to MR-46

[Mohit_Dhanjal]

Hi Team, 

I have new MR-46 access point, i want to assign manual IP address to this AP, i have connected the same with my access switch.

I don't have DHCP configuration in my switch, Without DHCP configuration through my laptop Can i assign manual IP to this AP. 

Also please suggest other method's.

Thanks & Regards

Mohit Dhanjal

[Ryan_Miles]

https://documentation.meraki.com/MR/MR_Installation_Guides/MR46_Installation_Guide#Static_Assignment

[Mohit_Dhanjal]

Hi Ryan,

Thanks for the update, i have already gone through this document.

My question is if DHCP is not working, which IP address i need to assign to my laptop, so that i can access AP local login page to configure manual IP.

Regards

Mohit

[alemabrahao]

[Mohit_Dhanjal]

Hi Alemabrahao,

Thanks for replying.

Do i need to connect my laptop and AP to same switch for this procedure. Also Switch that i am using is Cisco 9300 switch, do i need to perform any configuration on the same as well.

Regards

Mohit

[alemabrahao]

Just put both on the same VLAN

[Mohit_Dhanjal]

Do i require internet access when assigning manual IP's to access point. or without internet i can assign manual IP by connected laptop and AP in same VLAN

[Mohit_Dhanjal]

Do i require internet access when assigning manual IP's to access point. or without internet i can assign manual IP by connected laptop and AP in same VLAN

[alemabrahao]

You don't need internet access, you just need to configure the static IP on your machine and access the AP via IP 10.1281.28.126.