Jul 27 2021
8:30 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 27 2021
8:30 AM
Home network - can I connect MR24 through a NETGEAR unmanaged switch?
If so, do I need to change the configuration? When I plugged the AP into the switch the network no longer worked. It was previously connected directly onto the modem, but I need extra ports now.
Solved! Go to solution.
1 Accepted Solution
Jul 27 2021
9:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2 Replies 2
Jul 27 2021
9:27 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 27 2021
9:27 AM
Is the isp a modem or a nat router?
If its a ips modem that just provides 1 public ip you need a nat router.
If its a nat router. Then make sure its in routed mode and not in bridge mode
Jul 27 2021
9:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 27 2021
9:54 AM
modem. Thank you, I will get a NAT router.

Get notified when there are additional replies to this discussion.