I have a separate VLAN for Guest WiFi Access with Splash Through Access, when getting authenticated and an IP Address I cannot connect to the internet. Anyone else every experience this issue, my Guest SSID is tagged with the correct VLAN.
Solved! Go to solution.
@MerakiGuy90 In the two schools we have implemented the 26.2 release, we have seen our connectivity issues decrease significantly and performance is better than on the 25.13 release with MR34s.
We likely would have rolled all of our schools to the 26.2 release already but state testing has had to put those on hold until after it is completed.
What happens when you try to go online? Any errors, does it even make it out, or did you test your VLAN to make sure it is properly configured?
Just get a no internet, my VLAN looks correct to me, I am using Native VLAN 1 which is Prod, on the Switch that the Access Point is connected too. Guest is Network VLAN 10 and its tagged appropriately on the SSID.
Go to the Wireless - Wireless Health check the connections tab and see where it is failing. Let me know.
I worked with Meraki Support for over an hour last night, could not figure it out. I ended up deleting my Subnet for Guest and creating a new one and now it seems to be working ok. I was getting that same error but I was unable to browse to the internet at all. If we Whitelisted the Device it would connect, the issue is nothing was blocking it in the first place. Seems like the newly created Subnet may have fixed my issue.
Is your client showing up as authenticated int the guest logins section?
@MerakiGuy90 Which model of APs and firmware are you using?
Hi,
we are using MR32 and MR42 access points with 25.13 firmware version in all of them.
David
@DBabi and @MerakiGuy90 I would definitely look into implementing the 26.2 release, while listed as a Beta, it has fixed quite a few of the strange connectivity issues we had been seeing.
@MerakiGuy90 In the two schools we have implemented the 26.2 release, we have seen our connectivity issues decrease significantly and performance is better than on the 25.13 release with MR34s.
We likely would have rolled all of our schools to the 26.2 release already but state testing has had to put those on hold until after it is completed.