Hi,
I have a Virgin Media Router connected to a unmanaged switch and a printer and Cisco Meraki AP26 connected to the switch as well.
When I'm connected to the Virgin Media Router I (and my team) can print no problem
When I connect to the Meraki AP26, nobody can print.
The AP26 is set up in Bridge Mode
I've added a layer 3 firewall rule to allow TCP on the Printer IP Address on port 9100 (HP).
There is another FW rule that says Deny Any Local LAN to Any Port... does this need to be Allow???
I can't even PING the printer either when connected to Meraki?
Another issue is that when I use the HP Smart application to try and scan - the application can't even see the printer!?
Can any advise if I need to do seomthing on the Meraki setup somewhere to allow printing, scanning etc on my Meraki network?!?!?