Trying to tie an MX105 and C9300 together with a Direct Attach cable. Is it possible?

[JerryG]

I have an MX105 and I want to tie that MX to a new switch stack. I am thinking of going with the C9300X-24HX-M's with either a C9300X-NM-8Y-M or a C9300X-NM-8M. Are there any Direct Attach cables that work to tie both of those devices together? What I am reading the MX would want to use one of these MA-CBL-TA-1M and the C9300X would want to use a SFP-H25G-CU1M=. Does that mean neither would accept the other cable, even though physically it would fit in the same slot?

[Ryan_Miles]

I use a SFP-H10GB-CU1M to connect my MS355 to my MX95. Works fine. In general MXs accept a lot of brands of transceivers. Of course the disclaimer is this is the approved list of transceivers.

https://documentation.meraki.com/General_Administration/Cross-Platform_Content/Small-Form_Factor_Plu...

The SFP-H10GB-CU1M I use is also listed as supported on the 9300.

https://tmgmatrix.cisco.com/?npf=76&npf=1181&npf=601