Remove DHCP server on MS120

ChaVyzPro
Here to help

Remove DHCP server on MS120

Hi all,

 

I don't know why but DHCP server on MS120 have been configured all alone ???

after upgrading firmware yesterday ?

 

How to remove this, the wrong DHCP server Meraki is block and the right one Allowed

 

But after real reboot clients, they still have the wrong ip address . . . 

 

2023-05-24 232228 meraki 348 dhcp block.png

 

Kinds regards,

9 Replies 9
alemabrahao
Kind of a big deal
Kind of a big deal

I suggest you open a support case.

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

Hi

ok case already open, still working on it, but no hopes for the moment 

 

BlakeRichardson
Kind of a big deal
Kind of a big deal

Owch... Hopefully the issue hasn't caused too many problems for you. 

Hi

a little, but static ip is working . . .  DHCP ip no...

ChaVyzPro
Here to help

How can I downgrade MS firmware please ?

https://documentation.meraki.com/General_Administration/Firmware_Upgrades/Managing_Firmware_Upgrades

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

Hi,

 

Thanks but ...

 

I have read and try these two things but not working, or permitting me to do that

 

Rescheduling or Canceling a Firmware Upgrade

 

2023-05-25 134721 - Rescheduling or Canceling a Firmware Upgrade.png

 

 

Rolling Back a Recent Firmware Upgrade

 

2023-05-25 140759 - Rolling Back a Recent Firmware Upgrade.png

 

 

 

ChaVyzPro
Here to help

Solution ? change switch ... 

 

2023-05-25 141604 change swm.png

Kyle_Smith
Meraki Employee
Meraki Employee

I would check to make sure the management port is not connected to the network, since it will serve DHCP. This is so that you're able to connect to the local status page without setting a static IP.

https://documentation.meraki.com/General_Administration/Tools_and_Troubleshooting/Using_the_Cisco_Me...

Get notified when there are additional replies to this discussion.