Need some help converting from a 3650 cisco switch port config.

[dmacintire]

Here is one of the port
interface GigabitEthernet1/0/1
description NetApp FAS2552CL-01-e0a
switchport trunk encapsulation dot1q
switchport trunk native vlan 110
switchport mode trunk
flowcontrol receive desired
spanning-tree portfast trunk

Port two

interface GigabitEthernet1/0/4
description TDS VOICE SWITCH UPLINK
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 7
switchport mode trunk
switchport voice vlan 7
spanning-tree portfast

and we have a couple of port-channel groups for closet switches with are cisco 2690
interface Port-channel2
description Closet Switch Uplink
switchport trunk encapsulation dot1q
switchport mode trunk
spanning-tree portfast trunk

interface GigabitEthernet1/1/2
description Closet Switch Uplink
switchport trunk encapsulation dot1q
switchport mode trunk
srr-queue bandwidth share 1 30 35 5
priority-queue out
mls qos trust cos
auto qos trust
spanning-tree portfast trunk
channel-group 2 mode active

interface GigabitEthernet2/1/2
description Closet Switch Uplink
switchport trunk encapsulation dot1q
switchport mode trunk
srr-queue bandwidth share 1 30 35 5
priority-queue out
mls qos trust cos
auto qos trust
spanning-tree portfast trunk
channel-group 2 mode active

[PhilipDAth]

For GigabitEthernet1/0/1 you want something like:

Below is the most probably config for For Gig1/0/4GigabitEthernet1/0/1.  Note that "switchport voice vlan 7" only has affect for an access port - and the port is forcibly configured as a trunk port.  Also "spanning-tree portfast" will do nothing, as it is also only used for an access port.

[PhilipDAth]

For Gig1/1/2 and 2/1/2 you wont need to configure anything on the ports themselves.  You just need to aggregate that.  Follow this guide:

https://documentation.meraki.com/MS/Port_and_VLAN_Configuration/Switch_Ports#Selecting_Aggregate_por...