Meraki

Jeremy15

Can we poll the IP address of the End Point Device connected to Meraki Switch?

GIdenJoe

I believe you will need to poll dashboard instead. The MS switches themselves only know mac addresses but they will fingerprint traffic and see the IP address that way. But that is solely used to feed into dashboard.

alemabrahao

If you click on the switch port you can see some information about the client connected to it.

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

alemabrahao

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

Meraki

Community

NMS Application Polling the IP Address of the End Point Device Connected to Meraki Switch

NMS Application Polling the IP Address of the End Point Device Connected to Meraki Switch