Migrated C9300 No IPv6 Capabilities in Dashboard

[Lurick]

Just doing some lab testing on the C9300, I migrated one over to Meraki mode but I don't have any ability to configure IPv6 SVIs like I would if I had a MS390 in the dashboard. The release notes for MS15.21.1 say the migrated switches should have the same functionality as a MS390 which should have IPv6 SVI functionality on the dashboard yet I only see the ability to configure IPv4 interfaces, the dashboard doesn't show any IPv6 button like the config guides show either.

Did I miss something obvious?

[PhilipDAth]

Unless I missed something, the Meraki integration for the Catalysts is primary intended for monitoring the switches, not configuring them.

The "full managed mode" is very much a work in progress.

[Lurick]

https://community.meraki.com/t5/Feature-Announcements/Public-Preview-Available-Catalyst-9300-switch-...
This is what I'm referring to. I know about Catalyst Monitoring already.

[PhilipDAth]

You should consider this "beta".  It's a bit "rough" at the moment.

[Lurick]

Yah I'm just surprised or was hoping I missed something obvious to show IPv6 configs but I guess I shouldn't be too surprised, haha

[Lurick]

Looks like there might be a doc issue at least. I opened a case and support was surprised to say the least that the docs call out IPv6 SVIs 🙂

Still waiting to hear more though so we'll see what happens.