- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Migrated C9300 No IPv6 Capabilities in Dashboard
Just doing some lab testing on the C9300, I migrated one over to Meraki mode but I don't have any ability to configure IPv6 SVIs like I would if I had a MS390 in the dashboard. The release notes for MS15.21.1 say the migrated switches should have the same functionality as a MS390 which should have IPv6 SVI functionality on the dashboard yet I only see the ability to configure IPv4 interfaces, the dashboard doesn't show any IPv6 button like the config guides show either.
Did I miss something obvious?
- Labels:
-
Interfaces
-
Layer 3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Unless I missed something, the Meraki integration for the Catalysts is primary intended for monitoring the switches, not configuring them.
The "full managed mode" is very much a work in progress.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
https://community.meraki.com/t5/Feature-Announcements/Public-Preview-Available-Catalyst-9300-switch-...
This is what I'm referring to. I know about Catalyst Monitoring already.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You should consider this "beta". It's a bit "rough" at the moment.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yah I'm just surprised or was hoping I missed something obvious to show IPv6 configs but I guess I shouldn't be too surprised, haha
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Looks like there might be a doc issue at least. I opened a case and support was surprised to say the least that the docs call out IPv6 SVIs 🙂
Still waiting to hear more though so we'll see what happens.