Migrate from MS225 to C9200-M

[PinkUnicorn]

Both switches are Meraki managed - How can I swap one for the other one in the Meraki dashboard? Cloning only works between the same model switches (like for an RMA). Is there an easy way to move the configurations to the new switches? 

[GIdenJoe]

That's a tough one.
In the switchports page you can filter both switches out and port numbers.
So you could do (switch:SWMS225 OR switch:SWC9200) AND port:1
Or have two tabs open with each switch's ports filtered and just change the settings for each identical group of ports at a time.

Alternatively if you are versed with the dashboard API you could read the ports out that way and use an action batch to port config over.

[PinkUnicorn]

Yep, that's what I was thinking too - get a report via the API and use that as a guideline.

I just wanted to make sure there wasn't an easy button that I was missing. 

[DarrenOC]

No magic button in this instance. API or side by side view as previously mentioned 

[PhilipDAth]

This would be a good use case for the Google Chrome "split view" (right-click on a tab, and you can add another tab to the same view).

[tiffwalker]

Since Meraki does not allow you to clone settings between different models, you can simply copy the settings manually from one switch to another in the control panel. Try to document the VLAN, port configurations, and uplink settings. Then apply them to the new switch.