Migrate Cisco WS-C4948 configuration to Meraki MS225

[HThiam]

 I have the following configuration from a Cisco 4948 that I need to replace with an Meraki MS225 . How would I implemented this configuration onto the Meraki Dashboard ? 

interface Vlan1111
description HQ
no ip address
ip helper-address 10.10.10.9
!
ip route 0.0.0.0 0.0.0.0 10.10.1.1

Thank you 

[alemabrahao]

Take a look at the documentation.

https://documentation.meraki.com/MS/Layer_3_Switching/MS_Layer_3_Switching_and_Routing

[HThiam]

@alemabrahao  Thank you for the link. For DHCP relay, the documentation suggests that I should create an IPv4 Layer 3 SVI but as per the above configuration there is no ip address configured? 

Also, for the default static route referenced in the config, should I expect the management interface to handle the traffic? 

Thanks

[alemabrahao · Accepted solution]

This configuration doesn't make sense, if the Interface doesn't have an IP it can only be L2, this is probably an old configuration that was forgotten.

Default gateway: When creating the first IPv4 interface on a switch, you will be prompted to enter a default gateway address. This is the next hop IPv4 address of another device on the network, used for any traffic that isn't going to a directly connected subnet or over a static route. This IP address must exist in a subnet with a layer 3 interface, and will be used for the default route next hop IP address.

[HThiam]

Thank you for the feedback. You are probably right; this is indeed acting as layer 2 access switch and some of the configuration may be outdated.