Meraki MX-68 Communicate between VLANS

[cmal00]

Hi, 

I'm new with Meraki and using MXs. I was trying to have two different VLANS to be able to communicate between each other. I have a wireless VLAN 5  (laptops) that needs to go to a wired printer. (VLAN 10). Can't find where to configure that if possible.

Thanks

[Ryan_Miles]

Traffic should route between VLANs by default. There are no deny firewall rules by default (aside from outside to inside.)

[MartinLL]

It's routed by default. If you go to Security & SD-WAN > Firewall you can see the rule set controlling inter-VLAN communication as well as LAN to WAN. The default firewall rule is permit any. So as @Ryan_Miles states, it will just work by default.

[RWelch]

You can go to Security & SD-WAN > Configure > Firewall under Bonjour Forwarding and add services pertinent to your setup/configuration.

[PhilipDAth]

Make sure 'Deny Local LAN' is not enabled on your WiFi SSID.

https://documentation.meraki.com/MR/Firewall_and_Traffic_Shaping/'Deny_Local_LAN'_settings_in_Cisco_...

[cmal00]

 I had it Deny. I will test tomorrow at work. I'll let you know if it worked.

Thanks

[cmal00]

I'm able to ping now the other device on the other VLAN, looks like it's working...Thanks a bunch!

[PhilipDAth]

Have you managed to configure the two VLANs on the MX - or is that the bit you are getting stuck on?

If you have managed to configure the two VLANS - are machines on both able to talk to the Internet ok?