Manually Set PoE+ Power on Meraki Switch

[Markhaught]

Hello,

I have an an application that requires a PoE+ port to be set statically for maximum power output and ignore CDP or LLDP messages.   On Cisco Catalyst switches this can be done using PoE port static mode but I don’t see anything in the Meraki dashboard other than PoE enable/disable.   Can Meraki switch ports be set like this?

Thanks…Mark

[PhilipDAth · Accepted solution]

Not to the best of my knowledge.  PoE must be negotiated.

[Markhaught]

Thank you!

[alemabrahao]

Not at this moment.

[Markhaught]

Thank you!!