- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Looking for Power Cable Connector Specs for MA-PWR-1025WAC and MA-PWR-CORD-US for MS250 and MS355
Hi,
I am looking for the power cable connector specs for MA-PWR-1025WAC and MA-PWR-CORD-US which are being purchased with MS250-48FP and MS355-24X2 switches.
I am looking to purchase color coded power cables but need to know the exact connector sizes, but have not been able to find them looking at the Meraki datasheets.
Can anyone point me in the right direction?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
These are completely standard power cables. There is nothing Meraki specific about them.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'd just always buy C15 ended cables to ensure widest compatibility.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks. C15 Male and Female I am assuming?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
C15 on one end (part that goes into the switch/power supply), US plug on the other. Unless your rack uses PDU's, then replace US plug with what your PDU needs. Likely C19.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What specific size is standard then? Power supply vendors don't list a "Standard" size in their options.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What options are they giving you?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The socket on the PSU needs a high temperature power cord and connector as mentioned above (C15). Here is a good layman's guide: http://www.blogquail.com/the-difference-between-iec-connectors/
Any long enough manufactured cable with a C15 on one end and whatever power socket you have C14, C16 or country specific connector should be okay.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@cmr - hmmmm, should have read this post a few weeks back 😁
https://www.linkedin.com/in/darrenoconnor/
I'm not an employee of Cisco/Meraki. My posts are based on Meraki best practice and what has worked for me in the field.