Layer 3 Port Channel (LACP) on Meraki MS250 Switch stack

NirenVekaria
Comes here often

Layer 3 Port Channel (LACP) on Meraki MS250 Switch stack

Hi,

 

I am looking to do the Layer 3 port channel between the Meraki MS250 Stack. Do anyone has done it before as I can't seems to find any option to do the L3 Ethernet/port Channel on Meraki Switches.

 

A End (MS250 Stack in L3 mode)  <-->  B End (MS250 Stack in L3 mode). I need to assign the IP on both sides so that I can route the traffic over the Ethernet/Port channel.

 

Thanks in advance.

 

1 REPLY 1
PhilipDAth
Kind of a big deal
Kind of a big deal

You can only do a L2 port-channel.  You'll have to create a L3 VLAN, and either trunk it or make it an access port.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels